Windows 2000 Server
You install the Routing and Remote Access service on a Windows 2000 Server computer in your network. Your network is not directly connected to the Internet and uses the private IP address range 192.168.0.0. When you use Routing and Remote Access to dial in to the server, your computer connects successfully, but you are unable to access any resources. When you try to piiig servers by using their IP addresses, you receive the following message: "Request timed out." When you run the ipconfig command, it shows that your dial-up connection has been given the IP address 169.254.75.182. What should you do to resolve the problem?

Authorize the remote access server to receive multiple addresses from a DHCP server
Configure the remote access server with the address of a DHCP server
Ensure that the remote access server is able to connect to a DHCP server that has a scope for its subnet
Configure the remote access server to act as a DHCP Relay Agent
None of above

ANSWER DOWNLOAD EXAMIANS APP

Windows 2000 Server
You configure your Windows 2000 Server as a print server. You install a second PnP Network adapter to improve the performance. The first adapter uses IRQ11, and the second adapter uses IRQ5. The server is now unable to print to print devices connected to a non-PnP LPT2 port adapter. You want to continue to use the print devices connected to your print server. What should you do?

Edit the CMOS setting of the servers BIOS to reserve IRQ7 for non-PnP devices
None of above
Use device manager to change the IRQ for LPT1 to IRQ10
Edit the CMOS setting of the servers BIOS to reserve IRQ5 for non-PnP devices
Use device manager to change the IRQ for LPT2 to IRQ7

ANSWER DOWNLOAD EXAMIANS APP

Windows 2000 Server
Your computer has a mirrored volume and you wish to now install the Recovery Console for future troubleshooting. How do you do this?

None of above
Run the add and remove programs and add the recovery console
Break the mirror, run X:i386winnt32.exe /cmdcons Reestablish the mirror
Run X:i386winnt32.exe / cmdcons
Reinstall Windows, this can only be applied during the installation

ANSWER DOWNLOAD EXAMIANS APP

Windows 2000 Server
Your Windows 2000 Server computer uses a non-Plug and Play ISA modem configured to use IRQ 5. You add a PCI modem and restart the computer. Device Manager reports an IRQ conflict between the two modems. Both modem are trying to use IRQ 5. You want to resolve the problem. What should you do?

Use Device Manager to change the IRQ for the original modem to IRQ 10
Use Device Manager to change the IRQ for the original modem to IRQ 9
None Of above
Edit the CMOS settings on the computer to reserve IRQ 5 for non-Plug and Play devices
Edit the CMOS settings on the computer to reserve IRQ 10 for non-Plug and Play devices

ANSWER DOWNLOAD EXAMIANS APP

Windows 2000 Server
Your network contains NetWare 4.0 Servers. You have successfully installed Client Service for NetWare on Windows 2000 Professional computers, and Gateway Service for NetWare on Windows 2000 Server Computers. You recently added a new Windows 2000 Server computer to the network and installed Gateway Service for NetWare on it. However, the server is unable to connect to any NetWare servers. What should you do on the new Windows 2000 Server computer to resolve this problem?

Install the SAP Agent
Install RIP routing for IPX
Enable NWLink NetBIOS
None of above.
Configure the NWLink IPX/SPX/ NetBIOS Compatible Transport Protocol to use the correct Ethernet frame type

ANSWER DOWNLOAD EXAMIANS APP