Power Systems At slack bus, which one of the following combinations of variables is not specified? V and δ P and V P and Q Q and V V and δ P and V P and Q Q and V ANSWER DOWNLOAD EXAMIANS APP
Power Systems Which of the following contributes to the Rankine cycle efficiency improvement in a thermal power plant All of these Use of steam for heating of boiler feed water. Reheat of steam an intermediate stages. Use of high pressure. All of these Use of steam for heating of boiler feed water. Reheat of steam an intermediate stages. Use of high pressure. ANSWER DOWNLOAD EXAMIANS APP
Power Systems Ferranti effect occurs under any of the above full load no load half load any of the above full load no load half load ANSWER DOWNLOAD EXAMIANS APP
Power Systems Power system network has a total power of 5000 MW at 50 Hz supplying to the different consumers. Frequency is varying at 1.5% per change of 2% load. Assume R =0.004 Hz/MW. Find the steady state frequency deviation if a sudden loss of 200 MW occur due to tripping of one of the transmission line? 0.52 Hz 0.48 Hz -0.52 Hz 50 Hz 0.52 Hz 0.48 Hz -0.52 Hz 50 Hz ANSWER DOWNLOAD EXAMIANS APP
Power Systems Which of the following produces the radio interference in communication lines? both 1 and 2 None of these electro magnetic induction electro static induction both 1 and 2 None of these electro magnetic induction electro static induction ANSWER DOWNLOAD EXAMIANS APP
Power Systems A lossless power system has to serve a load of 250 MW. There are two generators(G1 and G2) in the system with cost curves C1 and C2 respectively defined as follows: C1 = PG1+0.055P²G1 C2 = 3 PG2 + 0.03 P²G2 Where PG1 and PG2 are the MW injections from generators G1 and G2 respectively. Thus, the minimum cost dispatch will be PG1 = 0 MW and PG2 = 250 MW PG1 = 150 MW and PG2 = 100 MW PG1 = 250 MW and PG2 = 0 MW PG1 = 100 MW and PG2 = 150 MW PG1 = 0 MW and PG2 = 250 MW PG1 = 150 MW and PG2 = 100 MW PG1 = 250 MW and PG2 = 0 MW PG1 = 100 MW and PG2 = 150 MW ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS