Railway Engineering Anti creep bearing plates are provided on joints both (A) and (B) bridges and approaches None of these joints both (A) and (B) bridges and approaches None of these ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering Tensile strength of steel used in rails should not be less than 850 MPa 700 MPa 500 MPa 450 MPa 850 MPa 700 MPa 500 MPa 450 MPa ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering The steepest gradient permissible on a 2.5° curve for Broad Gauge line having ruling gradient of 1 in 200 is 1 in 275 1 in 235 1 in 222 1 in 250 1 in 275 1 in 235 1 in 222 1 in 250 ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering Flat mild steel bearing plates are used On all joints and curves With wooden sleepers at locations where creep is likely to be developed On all the above For points and crossings in the lead portion On all joints and curves With wooden sleepers at locations where creep is likely to be developed On all the above For points and crossings in the lead portion ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering In a shunting signal if the red band is inclined at 45° it indicates proceed proceed cautiously None of these stop proceed proceed cautiously None of these stop ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering Switch angle depends oni) heel divergenceii) length of tongue railiii) flangeway clearanceiv) throw of switch The correct answer is (ii) and (iii) (i)and(iv) (iii) and (iv) (i) and (ii) (ii) and (iii) (i)and(iv) (iii) and (iv) (i) and (ii) ANSWER DOWNLOAD EXAMIANS APP