Machine Design A cotter joint is used to connect two __________ rods. None of these Co-axial Parallel Perpendicular None of these Co-axial Parallel Perpendicular ANSWER DOWNLOAD EXAMIANS APP
Machine Design A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where σ = Stress for a plate with no hole i.e. nominal stress) σ [1 + (2a/b)] σ [1 + (b/2a)] σ [1 + (b/3a)] σ [1 + (3a/b)] σ [1 + (2a/b)] σ [1 + (b/2a)] σ [1 + (b/3a)] σ [1 + (3a/b)] ANSWER DOWNLOAD EXAMIANS APP
Machine Design The ratio of circumferential stress to longitudinal stress in a thin cylinder subjected to an internal pressure is 1 4 2 43832 1 4 2 43832 ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft coupling should All of these Be easy to connect or disconnect Hold the shafts in perfect alignment Transmit full power of the shaft All of these Be easy to connect or disconnect Hold the shafts in perfect alignment Transmit full power of the shaft ANSWER DOWNLOAD EXAMIANS APP
Machine Design In order to obtain bolt of uniform strength Increase shank diameter Tighten die bolt properly Increase its length Drill an axial hole through head up to threaded portion so that shank area is equal to root area of thread Increase shank diameter Tighten die bolt properly Increase its length Drill an axial hole through head up to threaded portion so that shank area is equal to root area of thread ANSWER DOWNLOAD EXAMIANS APP
Machine Design If P1 and P2 are the tight and slack side tensions in the belt, then the initial tension Pi (neglecting centrifugal tension) will be equal to (Where, Pc is centrifugal tension) P1 - P2 [⅟₂ × (P1 + P2)] + Pc P1 + P2 ⅟₂ × (P1 + P2) P1 - P2 [⅟₂ × (P1 + P2)] + Pc P1 + P2 ⅟₂ × (P1 + P2) ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS