Machine Design The objective of caulking in a riveted joint is to make the joint Leak-proof Stronger in tension Free from corrosion Free from stress Leak-proof Stronger in tension Free from corrosion Free from stress ANSWER DOWNLOAD EXAMIANS APP
Machine Design I.S. specifies following total number of grades of tolerances 20 16 18 22 20 16 18 22 ANSWER DOWNLOAD EXAMIANS APP
Machine Design The ratio of driving tensions for flat belts, neglecting centrifugal tension, is (where T₁, and T₂ = Tensions on the tight and slack sides of belt respectively, μ = Coefficient of friction, between the belt and pulley, and θ = Angle of contact) T₁/T₂ =eμθ T₁/T₂ = μθ log (T₁/T₂) = μθ T₁/T₂ = log μθ T₁/T₂ =eμθ T₁/T₂ = μθ log (T₁/T₂) = μθ T₁/T₂ = log μθ ANSWER DOWNLOAD EXAMIANS APP
Machine Design The flank of the tooth is the Surface of the top of the tooth Width of the tooth measured along the pitch circle Surface of the tooth above the pitch surface Surface of the tooth below the pitch surface Surface of the top of the tooth Width of the tooth measured along the pitch circle Surface of the tooth above the pitch surface Surface of the tooth below the pitch surface ANSWER DOWNLOAD EXAMIANS APP
Machine Design In hydrostatic bearings The Oil film pressure is generated only by the rotation of the journal Grease is used for lubrication Do not require external supply of lubricant The oil film is maintained by supplying oil under pressure The Oil film pressure is generated only by the rotation of the journal Grease is used for lubrication Do not require external supply of lubricant The oil film is maintained by supplying oil under pressure ANSWER DOWNLOAD EXAMIANS APP
Machine Design When a helical compression spring is cut into halves, the stiffness of the resulting spring will be Double One-fourth Same One-half Double One-fourth Same One-half ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS