Machine Design In order to remove internal stresses produced by hardening the steel, the process usually adopted is Spheroidizing Tempering Normalizing Annealing Spheroidizing Tempering Normalizing Annealing ANSWER DOWNLOAD EXAMIANS APP
Machine Design For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately 0.7 times 0.8 times 0.4 times 0.6 times 0.7 times 0.8 times 0.4 times 0.6 times ANSWER DOWNLOAD EXAMIANS APP
Machine Design A flange coupling is used to connect two shafts Which are perfectly aligned Which are not in exact alignment Have lateral misalignment Whose axes intersect at a small angle Which are perfectly aligned Which are not in exact alignment Have lateral misalignment Whose axes intersect at a small angle ANSWER DOWNLOAD EXAMIANS APP
Machine Design The constant factor in case of R10 series of preferred numbers is 1.58 1.06 1.12 1.26 1.58 1.06 1.12 1.26 ANSWER DOWNLOAD EXAMIANS APP
Machine Design When screw threads are to be used in a situation where power is being transmitted in one direction only, then the screw threads suitable for this will be Buttress threads Square threads Knuckle threads Acme threads Buttress threads Square threads Knuckle threads Acme threads ANSWER DOWNLOAD EXAMIANS APP
Machine Design The contact ratio for gears is Zero Less than one Greater than one None of these Zero Less than one Greater than one None of these ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS