Machine Design When two springs are in series (having stiffness K), the equivalent stiffness will be 2K K/2 K/4 K 2K K/2 K/4 K ANSWER DOWNLOAD EXAMIANS APP
Machine Design Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d = Dia. of rivet hole, and σt = Permissible tensile stress for plate material) p.d.σt p.t.σt (p - d) t.σt p.d.σt p.t.σt (p - d) t.σt ANSWER DOWNLOAD EXAMIANS APP
Machine Design I.S. specifies following total number of grades of tolerances 16 18 20 22 16 18 20 22 ANSWER DOWNLOAD EXAMIANS APP
Machine Design If b denotes the face width and L denotes the cone distance for a bevel gear, then the bevel factor is written as 1 - (b/L) 1 - 2 b.L b/2L b/L 1 - (b/L) 1 - 2 b.L b/2L b/L ANSWER DOWNLOAD EXAMIANS APP
Machine Design Idler pulley is used for For applying tension Increasing velocity ratio All of these Changing the direction of motion of belt For applying tension Increasing velocity ratio All of these Changing the direction of motion of belt ANSWER DOWNLOAD EXAMIANS APP
Machine Design Tapered roller bearings can take Radial load only Axial load only Both radial and axial loads and the ratio of these being greater than unity Both radial and axial loads and the ratio of these being less than unity Radial load only Axial load only Both radial and axial loads and the ratio of these being greater than unity Both radial and axial loads and the ratio of these being less than unity ANSWER DOWNLOAD EXAMIANS APP