Machine Design Which of the following statement is correct for gears? The pitch circle diameter is equal to the product of module and number of teeth All of these The addendum is less than dedendum The pitch circle is always greater than the base circle The pitch circle diameter is equal to the product of module and number of teeth All of these The addendum is less than dedendum The pitch circle is always greater than the base circle ANSWER DOWNLOAD EXAMIANS APP
Machine Design In oilness bearings Do not require external supply of lubricant The oil film pressure is generated only by the rotation of the journal The oil film is maintained by supplying oil under pressure Grease required to be applied after some intervals Do not require external supply of lubricant The oil film pressure is generated only by the rotation of the journal The oil film is maintained by supplying oil under pressure Grease required to be applied after some intervals ANSWER DOWNLOAD EXAMIANS APP
Machine Design The expression 0.175 - 0.841/T is the Lewis form factor for 20° full depth involute system 14½° composite and full depth involute system None of these 20° stub system 20° full depth involute system 14½° composite and full depth involute system None of these 20° stub system ANSWER DOWNLOAD EXAMIANS APP
Machine Design In skew bevel gearing, the axes of shafts are None of these Non-intersecting and nonparallel and the teeth are curved Intersecting and the teeth are curved Non-intersecting and non-parallel and the teeth are straight None of these Non-intersecting and nonparallel and the teeth are curved Intersecting and the teeth are curved Non-intersecting and non-parallel and the teeth are straight ANSWER DOWNLOAD EXAMIANS APP
Machine Design When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor, and W = Axial compressive load on the spring) (WD/ πd3) × K (2WD/ πd3) × K (4WD/ πd3) × K (8WD/ πd3) × K (WD/ πd3) × K (2WD/ πd3) × K (4WD/ πd3) × K (8WD/ πd3) × K ANSWER DOWNLOAD EXAMIANS APP
Machine Design A cotter joint is used to connect two __________ rods. None of these Parallel Co-axial Perpendicular None of these Parallel Co-axial Perpendicular ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS