Machine Design When a beam of rectangular cross-section of width b and depth d, is subjected to a shear force F, the maximum shear stress induced will be F/bh 3F/2bh 2F/bh 4F/bh F/bh 3F/2bh 2F/bh 4F/bh ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be 3.0 2.5 2.8 3.5 3.0 2.5 2.8 3.5 ANSWER DOWNLOAD EXAMIANS APP
Machine Design In unilateral system of tolerance, the tolerance is allowed on Both sides of the nominal size Both sides of the actual size One side of the actual size One side of the nominal size Both sides of the nominal size Both sides of the actual size One side of the actual size One side of the nominal size ANSWER DOWNLOAD EXAMIANS APP
Machine Design A sliding bearing which operates without any lubricant present, is called Hydrostatic lubricated bearing Zero film bearing Hydrodynamic lubricated bearing Boundary lubricated bearing Hydrostatic lubricated bearing Zero film bearing Hydrodynamic lubricated bearing Boundary lubricated bearing ANSWER DOWNLOAD EXAMIANS APP
Machine Design The notch sensitivity q is expressed in terms of fatigue stress concentration factor Kf and theoretical stress concentration factor Kt as (Kt - 1)/ (Kf - 1) (Kt + 1)/ (Kf + 1) (Kf - 1)/ (Kt - 1) (Kf + 1)/ (Kt + 1) (Kt - 1)/ (Kf - 1) (Kt + 1)/ (Kf + 1) (Kf - 1)/ (Kt - 1) (Kf + 1)/ (Kt + 1) ANSWER DOWNLOAD EXAMIANS APP
Machine Design If the tearing efficiency of a riveted joint is 75%, then the ratio of diameter of rivet to the pitch is equal to 0.6 0.2 0.25 0.5 0.6 0.2 0.25 0.5 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS