Machine Design Which of the following coupling is used to connect two shafts which have both lateral and angular misalignment? Bushed pin type coupling All of these Oldham coupling Universal coupling Bushed pin type coupling All of these Oldham coupling Universal coupling ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a belt drive, if the pulley diameter is doubled keeping the tension and belt width constant, then it will be necessary to Increase the key depth Increase the key width Increase the key length Decrease the key length Increase the key depth Increase the key width Increase the key length Decrease the key length ANSWER DOWNLOAD EXAMIANS APP
Machine Design The objective of 'crowning' of the flat pulleys of belt drive is to Prevent the belt joint from damaging the belt surface Increase the belt velocity Increase the power transmission capacity Prevent the belt from running off the pulley Prevent the belt joint from damaging the belt surface Increase the belt velocity Increase the power transmission capacity Prevent the belt from running off the pulley ANSWER DOWNLOAD EXAMIANS APP
Machine Design The resultant axial load on a bolt depends upon Relative elastic yielding of the bolt and the connected members Initial tension due to tightening of the bolt All of these External load applied Relative elastic yielding of the bolt and the connected members Initial tension due to tightening of the bolt All of these External load applied ANSWER DOWNLOAD EXAMIANS APP
Machine Design The size of a gear is usually specified by Circular pitch Pressure angle Diametral pitch Pitch circle diameter Circular pitch Pressure angle Diametral pitch Pitch circle diameter ANSWER DOWNLOAD EXAMIANS APP
Machine Design A circular shaft can transmit a torque of 5 kN-m. If the torque is reduced to 4 kN-m, then the maximum value of bending moment that can be applied to the shaft is 3 kN-m 1 kN-m 4 kN-m 2 kN-m 3 kN-m 1 kN-m 4 kN-m 2 kN-m ANSWER DOWNLOAD EXAMIANS APP