Machine Design According to Indian standard specifications, 100 H6/g5 means that Tolerance grade for the hole is 4 to 8 and for the shaft is 3 to 7 Tolerance grade for the shaft is 4 to 8 and for the hole is 3 to 7 Tolerance grade for the hole is 6 and for the shaft is 5 Tolerance grade for the shaft is 6 and for the hole is 5 Tolerance grade for the hole is 4 to 8 and for the shaft is 3 to 7 Tolerance grade for the shaft is 4 to 8 and for the hole is 3 to 7 Tolerance grade for the hole is 6 and for the shaft is 5 Tolerance grade for the shaft is 6 and for the hole is 5 ANSWER DOWNLOAD EXAMIANS APP
Machine Design A spring of stiffness 1000 N/m is stretched initially by 100 mm from the undeformed position. The work required to stretch it by another 100 mm is 5 N-m 7 N-m 15 N-m 10 N-m 5 N-m 7 N-m 15 N-m 10 N-m ANSWER DOWNLOAD EXAMIANS APP
Machine Design The pitch of threads on a Jock nut in comparison to pitch of nut is Coarser Finer Same Very fine Coarser Finer Same Very fine ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a multiple V-belt drive, when a single belt is damaged, it is preferable to change the complete set in order to Ensure proper alignment Reduce vibration Reduce slip Ensure uniform loading Ensure proper alignment Reduce vibration Reduce slip Ensure uniform loading ANSWER DOWNLOAD EXAMIANS APP
Machine Design The plasticity is the property of a material which enables it to Draw into wires by the application of a tensile force Resist fracture due to high impact loads Regain its original shape after deformation when the external forces are removed Retain deformation produced under load permanently Draw into wires by the application of a tensile force Resist fracture due to high impact loads Regain its original shape after deformation when the external forces are removed Retain deformation produced under load permanently ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a band and block brake, the ratio of tensions on the tight and slack sides of band is given by (where μ = Coefficient of friction between the blocks and the drum, θ = Semi-angle of each block subtending at the centre of drum, and n = Number of blocks) T₁/T₂ = [(1 - μ tanθ)/ (1 + μ tanθ)]n T₁/T₂ = [(1 + μ tanθ)/ (1 - μ tanθ)]n T₁/T₂ = (μθ)n T₁/T₂ = μθ × n T₁/T₂ = [(1 - μ tanθ)/ (1 + μ tanθ)]n T₁/T₂ = [(1 + μ tanθ)/ (1 - μ tanθ)]n T₁/T₂ = (μθ)n T₁/T₂ = μθ × n ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS