Machine Design The steel pulleys are __________ in weight than cast iron pulleys of the same capacity. None of these Heavier Lighter Moderate None of these Heavier Lighter Moderate ANSWER DOWNLOAD EXAMIANS APP
Machine Design The objective of 'crowning' of the flat pulleys of belt drive is to Increase the power transmission capacity Prevent the belt joint from damaging the belt surface Increase the belt velocity Prevent the belt from running off the pulley Increase the power transmission capacity Prevent the belt joint from damaging the belt surface Increase the belt velocity Prevent the belt from running off the pulley ANSWER DOWNLOAD EXAMIANS APP
Machine Design The V-belts are particularly suitable for __________ drives. Long None of these Short Both A and B Long None of these Short Both A and B ANSWER DOWNLOAD EXAMIANS APP
Machine Design The resultant axial load on a bolt depends upon Relative elastic yielding of the bolt and the connected members All of these External load applied Initial tension due to tightening of the bolt Relative elastic yielding of the bolt and the connected members All of these External load applied Initial tension due to tightening of the bolt ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to fluctuating loads for which the normal torque (T) and bending moment (M) are 1000 N-m and 500 N-m respectively. If the combined shock and fatigue factor for bending is 1.5 and combined shock and fatigue factor for torsion is 2, then the equivalent twisting moment for the shaft is 2136 N-m 2100 N-m 2050 N-m 2000 N-m 2136 N-m 2100 N-m 2050 N-m 2000 N-m ANSWER DOWNLOAD EXAMIANS APP
Machine Design The static tooth load should be __________ the dynamic load. Greater than None of these Less than Equal to Greater than None of these Less than Equal to ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS