Machine Design The material commonly used for crane hooks is Wrought iron Cast iron Aluminium Mild steel Wrought iron Cast iron Aluminium Mild steel ANSWER DOWNLOAD EXAMIANS APP
Machine Design A leaf spring in automobiles is used To measure forces To apply forces To absorb shocks To store strain energy To measure forces To apply forces To absorb shocks To store strain energy ANSWER DOWNLOAD EXAMIANS APP
Machine Design The objective of 'crowning' of the flat pulleys of belt drive is to Prevent the belt joint from damaging the belt surface Increase the belt velocity Increase the power transmission capacity Prevent the belt from running off the pulley Prevent the belt joint from damaging the belt surface Increase the belt velocity Increase the power transmission capacity Prevent the belt from running off the pulley ANSWER DOWNLOAD EXAMIANS APP
Machine Design A column is known as a long column if the slenderness ratio is 70 40 50 100 70 40 50 100 ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be 2.5 2.8 3.0 3.5 2.5 2.8 3.0 3.5 ANSWER DOWNLOAD EXAMIANS APP
Machine Design A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where σ = Stress for a plate with no hole i.e. nominal stress) σ [1 + (2a/b)] σ [1 + (3a/b)] σ [1 + (b/3a)] σ [1 + (b/2a)] σ [1 + (2a/b)] σ [1 + (3a/b)] σ [1 + (b/3a)] σ [1 + (b/2a)] ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS