Railway Engineering The height of the center of arm of a semaphore signal above the ground is 6.5 m 8.5m 7.5 m 5.5m 6.5 m 8.5m 7.5 m 5.5m ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering Cant deficiency occurs when a vehicle travels around a curve at Booked speed Speeds higher than equilibrium speed Speeds lower than equilibrium speed Equilibrium speed Booked speed Speeds higher than equilibrium speed Speeds lower than equilibrium speed Equilibrium speed ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering The load on each axle of a locomotive is 22 tonnes. If the coefficient of friction is 0.2, then the hauling capacity due to 3 pairs of driving wheels will be 19.81 13.21 6.61 26.41 19.81 13.21 6.61 26.41 ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering Flat mild steel bearing plates are used On all joints and curves On all the above For points and crossings in the lead portion With wooden sleepers at locations where creep is likely to be developed On all joints and curves On all the above For points and crossings in the lead portion With wooden sleepers at locations where creep is likely to be developed ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering The nominal size of ballast used for points and crossings is 10 mm 50 mm 40 mm 25 mm 10 mm 50 mm 40 mm 25 mm ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering Creep is the Longitudinal movement of rail Lateral movement of rail Vertical movement of rail Difference in level of two rails Longitudinal movement of rail Lateral movement of rail Vertical movement of rail Difference in level of two rails ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS