Machine Design The endurance or fatigue limit is defined as the maximum value of the stress which a polished standard specimen can withstand without failure, for infinite number of cycles, when subjected to Dynamic load Static load Static as well as dynamic load Completely reversed load Dynamic load Static load Static as well as dynamic load Completely reversed load ANSWER DOWNLOAD EXAMIANS APP
Machine Design A double strap butt joint (with equal straps) is Either in single shear or double shear Always in single shear Always in double shear Any one of these Either in single shear or double shear Always in single shear Always in double shear Any one of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design Two shafts of the same length and material are joined in series. If the ratio of their diameters is 2, then the ratio of their angles of twist will be 2 8 16 4 2 8 16 4 ANSWER DOWNLOAD EXAMIANS APP
Machine Design The difference between the upper limit and lower limit of a dimension is called Actual size Basic size Nominal size Tolerance Actual size Basic size Nominal size Tolerance ANSWER DOWNLOAD EXAMIANS APP
Machine Design The velocity factor for ordinary cut gears operating at velocities up to 12.5 m/s is equal to 0.75/(0.75 + √v) 6/(6 + v) 3/(3 + v) 4.5/(4.5 + v) 0.75/(0.75 + √v) 6/(6 + v) 3/(3 + v) 4.5/(4.5 + v) ANSWER DOWNLOAD EXAMIANS APP
Machine Design Gears are casted by Sand mould casting Centrifugal casting Slush casting Permanent mould casting Sand mould casting Centrifugal casting Slush casting Permanent mould casting ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS