Machine Design The condition for maximum power transmission is that the maximum tension in the flat belt should be equal to(Where, Pc = tension in belt due to centrifugal force) 1 Pc 2 Pc 3 Pc Pc/3 1 Pc 2 Pc 3 Pc Pc/3 ANSWER DOWNLOAD EXAMIANS APP
Machine Design Which of the following pipe joints would be suitable for pipes carrying steam? Expansion Flanged Bell and spigot Threaded Expansion Flanged Bell and spigot Threaded ANSWER DOWNLOAD EXAMIANS APP
Machine Design Transverse fillet welded joints are designed for Shear strength Compressive strength Tensile strength Bending strength Shear strength Compressive strength Tensile strength Bending strength ANSWER DOWNLOAD EXAMIANS APP
Machine Design When compared to the rod of the same diameter and material, a wire rope Does not provide much warning before failure Provides much greater time for remedial action before failure Is less flexible Has a much smaller load carrying capacity Does not provide much warning before failure Provides much greater time for remedial action before failure Is less flexible Has a much smaller load carrying capacity ANSWER DOWNLOAD EXAMIANS APP
Machine Design If a load W is applied instantaneously on a bar; Then the stress induced in bar will Depend on other considerations Decrease with decrease in y Be independent of ratio of mass of load W to mass of bar (y) Increase with increase in y Depend on other considerations Decrease with decrease in y Be independent of ratio of mass of load W to mass of bar (y) Increase with increase in y ANSWER DOWNLOAD EXAMIANS APP
Machine Design A compound cylinder with inner radius 50 mm and outer radius 70 mm is made by shrinking one cylinder on to the other cylinder, the junction radius is 60 mm and the junction pressure is 1.1 N/mm². The maximum hoop stress developed in the inner cylinder is 3.6 N/mm² compression 7.2 N/mm² compression 3.6 N/mm² tension 7.2 N/mm² tension 3.6 N/mm² compression 7.2 N/mm² compression 3.6 N/mm² tension 7.2 N/mm² tension ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS