Machine Design When compared to the rod of the same diameter and material, a wire rope Has a much smaller load carrying capacity Is less flexible Does not provide much warning before failure Provides much greater time for remedial action before failure Has a much smaller load carrying capacity Is less flexible Does not provide much warning before failure Provides much greater time for remedial action before failure ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be 2.8 3 3.5 2.5 2.8 3 3.5 2.5 ANSWER DOWNLOAD EXAMIANS APP
Machine Design An elastic bar is fixed at the upper end and loaded at the lower end by a falling weight. The shock load produced can be reduced by Increasing the length of bar All of these Decreasing the cross-sectional area of the bar Decreasing the modulus of elasticity of the bar Increasing the length of bar All of these Decreasing the cross-sectional area of the bar Decreasing the modulus of elasticity of the bar ANSWER DOWNLOAD EXAMIANS APP
Machine Design For crank shaft bearings, the ratio of the length of the journal to its diameter is_________. None of these Less than unity Equal to 1 Greater than unity None of these Less than unity Equal to 1 Greater than unity ANSWER DOWNLOAD EXAMIANS APP
Machine Design According to Indian standard specifications, a Grey cast iron designated by 'FG 200' means that the Minimum tensile strength is 200 N/mm² Maximum shear strength is 200 N/mm² Maximum compressive strength is 200 N/mm² Carbon content is 2% Minimum tensile strength is 200 N/mm² Maximum shear strength is 200 N/mm² Maximum compressive strength is 200 N/mm² Carbon content is 2% ANSWER DOWNLOAD EXAMIANS APP
Machine Design For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately 0.6 times 0.7 times 0.8 times 0.4 times 0.6 times 0.7 times 0.8 times 0.4 times ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS