Machine Design In the assembly of pulley, key and shaft Pulley is made the weakest All the three are designed for equal strength Key is made the strongest Key is made the weakest Pulley is made the weakest All the three are designed for equal strength Key is made the strongest Key is made the weakest ANSWER DOWNLOAD EXAMIANS APP
Machine Design The minimum number of teeth on the pinion which will mesh with any gear without interference for 20° full depth involute teeth will be 12 18 24 14 12 18 24 14 ANSWER DOWNLOAD EXAMIANS APP
Machine Design When the belt speed increases Power transmitted remains the same Power transmitted decreases Power transmitted increases to a maximum value and then decreases Power transmitted increases Power transmitted remains the same Power transmitted decreases Power transmitted increases to a maximum value and then decreases Power transmitted increases ANSWER DOWNLOAD EXAMIANS APP
Machine Design A coupling used to connect two perfectly aligned shafts, is Muff coupling All of these Compression coupling Flange coupling Muff coupling All of these Compression coupling Flange coupling ANSWER DOWNLOAD EXAMIANS APP
Machine Design The wear load should be __________ the dynamic load. Equal to Less than None of these Greater than Equal to Less than None of these Greater than ANSWER DOWNLOAD EXAMIANS APP
Machine Design The material used for brake lining should have __________ coefficient of friction. Low High None of these Moderate Low High None of these Moderate ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS