Machine Design A compound belt drive is used when None of these Shafts are arranged parallel and rotate in the same directions Shafts are arranged at right angles and rotate in one definite direction Shafts are arranged parallel and rotate in the opposite directions None of these Shafts are arranged parallel and rotate in the same directions Shafts are arranged at right angles and rotate in one definite direction Shafts are arranged parallel and rotate in the opposite directions ANSWER DOWNLOAD EXAMIANS APP
Machine Design Two helical springs of the same material and of equal circular cross-section, length and number of turns, but having radii 80 mm and 40 mm, kept concentrically (smaller radius spring within the larger radius spring), are compressed between two parallel planes with a load W. The inner spring will carry a load equal to W/2 W/9 2W/3 8W/9 W/2 W/9 2W/3 8W/9 ANSWER DOWNLOAD EXAMIANS APP
Machine Design In replacing the V-belts, a complete set of new belts is used instead of replacing a single damaged belt because New and old belts will cause vibrations Only one belt cannot be fitted with other used belts The new belt will carry more than its share and result in short life Belts are available in sets New and old belts will cause vibrations Only one belt cannot be fitted with other used belts The new belt will carry more than its share and result in short life Belts are available in sets ANSWER DOWNLOAD EXAMIANS APP
Machine Design For a square key made of mild steel, the shear and crushing strength are related as Shear strength is greater than crushing strength Shear strength is equal to crushing strength Shear strength is less than crushing strength None of these Shear strength is greater than crushing strength Shear strength is equal to crushing strength Shear strength is less than crushing strength None of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design The ratio of pitch circle diameter in millimeters to the number of teeth, is called Circular pitch Diametral pitch None of these Module Circular pitch Diametral pitch None of these Module ANSWER DOWNLOAD EXAMIANS APP
Machine Design The expression 0.175 - 0.841/T is the Lewis form factor for 20° stub system None of these 20° full depth involute system 14½° composite and full depth involute system 20° stub system None of these 20° full depth involute system 14½° composite and full depth involute system ANSWER DOWNLOAD EXAMIANS APP