Machine Design In designing a sleeve coupling, length of the sleeve is taken as (where d = Diameter of the shaft) d + 17 mm 2d + 20 mm 2d + 13 mm 3.5 d d + 17 mm 2d + 20 mm 2d + 13 mm 3.5 d ANSWER DOWNLOAD EXAMIANS APP
Machine Design The largest diameter of an external or internal screw thread is known as Major diameter None of these Minor diameter Pitch diameter Major diameter None of these Minor diameter Pitch diameter ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a flange coupling, the bolts are subjected to Tensile stress Shear stress Compressive stress None of these Tensile stress Shear stress Compressive stress None of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be 2.8 3.5 2.5 3.0 2.8 3.5 2.5 3.0 ANSWER DOWNLOAD EXAMIANS APP
Machine Design A locking device extensively used in marine type connecting rod ends is a Jam nut Ring nut Castle nut Sawn nut Jam nut Ring nut Castle nut Sawn nut ANSWER DOWNLOAD EXAMIANS APP
Machine Design In worm gears, the angle between the tangent to the pitch helix and an element of the cylinder, is known as None of these Pitch lead angle Pressure angle Helix angle None of these Pitch lead angle Pressure angle Helix angle ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS