Machine Design The connecting rod bolts are tightened up so that tightening stress Is 50% of yield point Is just sufficient to hold parts together Approaches yield point Is about yield point divided by safety factor Is 50% of yield point Is just sufficient to hold parts together Approaches yield point Is about yield point divided by safety factor ANSWER DOWNLOAD EXAMIANS APP
Machine Design While designing a screw in a screw jack against buckling failure, the end conditions for the screw are taken as Both the ends fixed Both the ends hinged One end fixed and the other end free One end fixed and the other end hinged Both the ends fixed Both the ends hinged One end fixed and the other end free One end fixed and the other end hinged ANSWER DOWNLOAD EXAMIANS APP
Machine Design The creep in the belt is due to Material of belt Effect of temperature on belt Unequal extensions in the belt due to tight and slack side tensions Stresses beyond elastic limit of belt material Material of belt Effect of temperature on belt Unequal extensions in the belt due to tight and slack side tensions Stresses beyond elastic limit of belt material ANSWER DOWNLOAD EXAMIANS APP
Machine Design A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where σ = Stress for a plate with no hole i.e. nominal stress) σ [1 + (3a/b)] σ [1 + (2a/b)] σ [1 + (b/2a)] σ [1 + (b/3a)] σ [1 + (3a/b)] σ [1 + (2a/b)] σ [1 + (b/2a)] σ [1 + (b/3a)] ANSWER DOWNLOAD EXAMIANS APP
Machine Design The size of a gear is usually specified by Pressure angle Diametral pitch Pitch circle diameter Circular pitch Pressure angle Diametral pitch Pitch circle diameter Circular pitch ANSWER DOWNLOAD EXAMIANS APP
Machine Design If P1 and P2 are the tight and slack side tensions in the belt, then the initial tension Pi (neglecting centrifugal tension) will be equal to (Where, Pc is centrifugal tension) ⅟₂ × (P1 + P2) [⅟₂ × (P1 + P2)] + Pc P1 + P2 P1 - P2 ⅟₂ × (P1 + P2) [⅟₂ × (P1 + P2)] + Pc P1 + P2 P1 - P2 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS