Machine Design In cross or regular lay ropes Direction of twist of wires in strands is opposite to the direction of twist of strands Direction of twist of wires and strands are same Wires in two adjacent strands are twisted in opposite direction Wires are not twisted Direction of twist of wires in strands is opposite to the direction of twist of strands Direction of twist of wires and strands are same Wires in two adjacent strands are twisted in opposite direction Wires are not twisted ANSWER DOWNLOAD EXAMIANS APP
Machine Design The value of stress concentration factor depends upon None of these Geometry of the part Material and geometry of the part Material of the part None of these Geometry of the part Material and geometry of the part Material of the part ANSWER DOWNLOAD EXAMIANS APP
Machine Design The groove angle of the pulley for rope drive is usually 45° 35° 60° 20° 45° 35° 60° 20° ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be 3.0 2.5 3.5 2.8 3.0 2.5 3.5 2.8 ANSWER DOWNLOAD EXAMIANS APP
Machine Design In case of pressure vessels having open ends, the fluid pressure induces Shear stress Circumferential stress None of these Longitudinal stress Shear stress Circumferential stress None of these Longitudinal stress ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a steam engine, the piston rod is usually connected to the cross-head by means of a Knuckle joint Universal joint Cotter joint Oldham coupling Knuckle joint Universal joint Cotter joint Oldham coupling ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS