Theory of Machine In a cone pulley, if the sum of radii of the pulleys on the driving and driven shafts is constant, then Crossed belt drive is recommended The drive is recommended depending upon the torque transmitted Open belt drive is recommended Both open belt drive and crossed belt drive is recommended Crossed belt drive is recommended The drive is recommended depending upon the torque transmitted Open belt drive is recommended Both open belt drive and crossed belt drive is recommended ANSWER DOWNLOAD EXAMIANS APP
Theory of Machine The relation l = (2/3).(j + 2) apply only to kinematic chains in which lower pairs are used. This may be used to kinematic chains in which higher pairs are used, but each higher pair may be taken as equivalent to Two lower pairs and one additional link Two lower pairs and two additional links Any one of these One lower pair and two additional links Two lower pairs and one additional link Two lower pairs and two additional links Any one of these One lower pair and two additional links ANSWER DOWNLOAD EXAMIANS APP
Theory of Machine In gears, interference takes place when The tip of a tooth of a mating gear digs into the portion between base and root circles Gear teeth are undercut Pitch of the gears is not same Gears do not move smoothly in the absence of lubrication The tip of a tooth of a mating gear digs into the portion between base and root circles Gear teeth are undercut Pitch of the gears is not same Gears do not move smoothly in the absence of lubrication ANSWER DOWNLOAD EXAMIANS APP
Theory of Machine The power from the engine to the rear axle of an automobile is transmitted by means of Bevel gears Worm and worm wheel Spur gears Hooke's joint Bevel gears Worm and worm wheel Spur gears Hooke's joint ANSWER DOWNLOAD EXAMIANS APP
Theory of Machine The frequency of oscillation of a torsional pendulum is r/2πk. √(l/g) r/2πk. √(g/l) 2πk/r. √(g/l) 2πr/k. √(g/l) r/2πk. √(l/g) r/2πk. √(g/l) 2πk/r. √(g/l) 2πr/k. √(g/l) ANSWER DOWNLOAD EXAMIANS APP
Theory of Machine A torsional system with discs of moment of inertia I₁ and I₂ as shown in the below figure, is gear driven such that the ratio of speed of shaft B to shaft A is 'G'. Neglecting the inertia of gears, the equivalent inertia of disc on shaft B at the speed of shaft A is equal to G².I₂ G.I₂ I₂/G² I₂/G G².I₂ G.I₂ I₂/G² I₂/G ANSWER DOWNLOAD EXAMIANS APP