Building Construction For effective drainage, the finished surface of flat roof should have a minimum slope of 1 to 50 1 in 20 1 in 5 1 in 10 1 to 50 1 in 20 1 in 5 1 in 10 ANSWER DOWNLOAD EXAMIANS APP
Building Construction Grillage foundation All listed here Does not require deep cutting as the required base area with required pressure intensity is obtained at a shallow depth Is light and economical Is used to transfer heavy structural loads from steel columns to a soil having low bearing capacity All listed here Does not require deep cutting as the required base area with required pressure intensity is obtained at a shallow depth Is light and economical Is used to transfer heavy structural loads from steel columns to a soil having low bearing capacity ANSWER DOWNLOAD EXAMIANS APP
Building Construction Two columns 50 cm × 50 cm and 60 cm × 60 cm carry 80 tonnes and 120 tonnes of loads respectively. The centre to centre distance between columns is 5.00 metres. The permissible bearing capacity of the soil is 20 t/m2. If the footing is not to project more than 25 cm beyond the outside of the smaller column, pick up the correct design parameters of the footing from the following: All listed here Distance of C.G. of the loads from the smaller column = 3.00 m Area of footing slab = 11.00 m2 The length of the foundation slab = 7.00 m All listed here Distance of C.G. of the loads from the smaller column = 3.00 m Area of footing slab = 11.00 m2 The length of the foundation slab = 7.00 m ANSWER DOWNLOAD EXAMIANS APP
Building Construction In flat roof of reinforced cement concrete, the recommended angle of slope, is Zero 10° 200° A few degrees Zero 10° 200° A few degrees ANSWER DOWNLOAD EXAMIANS APP
Building Construction The type of ashlar masonry in which stones are finely chisel dressed and thickness of joints does not exceed 3 mm, is Ashlar facing masonry Coursed ashlar masonry Chamfered ashlar masonry Random coursed ashlar masonry Ashlar facing masonry Coursed ashlar masonry Chamfered ashlar masonry Random coursed ashlar masonry ANSWER DOWNLOAD EXAMIANS APP
Building Construction The type of joint commonly used at the junction of a principal rafter and tie beam in timber trusses is Mortise and tenon joint Butt joint Oblique mortise and tenon joint Mitred joint Mortise and tenon joint Butt joint Oblique mortise and tenon joint Mitred joint ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS