Process Equipment and Plant Design A 'rupture disc' is provided in chemical equipments as an accessory meant for Avoiding vortex formation Creating turbulence Enhancing mixing rate Relieving excess pressure Avoiding vortex formation Creating turbulence Enhancing mixing rate Relieving excess pressure ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design Any shell opening greater than 5 cms for a storage tank must be reinforced for reason of Making the joint leak proof Reduction of discontinuity in shape at the junction None of these Preventing the local overstressing of the shell around the opening Making the joint leak proof Reduction of discontinuity in shape at the junction None of these Preventing the local overstressing of the shell around the opening ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by(where, Q = fluid flow rate, ft³/sec.ρ = fluid density, lb/ft³ μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches) Di, opt = 3 Q0.36 . μ0.88 Di, opt = 3.9 Q0.45 . μ0.95 Di, opt = 3.9 Q0.45 ρ0.13 Di, opt = 4.7 Q0.36 . μ3.2ρ0.13 Di, opt = 3 Q0.36 . μ0.88 Di, opt = 3.9 Q0.45 . μ0.95 Di, opt = 3.9 Q0.45 ρ0.13 Di, opt = 4.7 Q0.36 . μ3.2ρ0.13 ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design In a shell and tube heat exchanger, the 'tube pitch' is defined as the Shortest distance between two adj acent tube holes Shortest centre to centre distance between adjacent tubes O.D. of the tube for square pitch None of these Shortest distance between two adj acent tube holes Shortest centre to centre distance between adjacent tubes O.D. of the tube for square pitch None of these ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design The slope of operating line in the rectifying section of a distillation column is unity, if the reflux ratio is ∞ 0 Minimum 1 ∞ 0 Minimum 1 ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design The distance between the centre of a rivet hole to the nearest edge of the plate is called Pitch Back pitch None of these Margin Pitch Back pitch None of these Margin ANSWER DOWNLOAD EXAMIANS APP