Measurement and Instrumentation A CRO probe has an impedance of 500 kΩ in parallel with a capacitance of 10 pF. The probe is used to measure the voltage between P and Q as shown in figure. The measured voltage will be 4.54 V. 5 V. 3.53 V. 4.38 V. 4.54 V. 5 V. 3.53 V. 4.38 V. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A sinusoidal signal waveform, when observed on an oscilloscope, has a peak to peak amplitude of 6 cm. If the vertical sensitivity setting is 5 v/cm, then rms value of the voltage will be 11.1 V. 15 V. 10.6 V. 12.6 V. 11.1 V. 15 V. 10.6 V. 12.6 V. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Unit of deflection sensitivity of a CRO is V / mm. mm per mV. mm / V. meter / volt. V / mm. mm per mV. mm / V. meter / volt. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Which of the following quantities consists of S.I. unit as Hertz? Power Charge Force Frequency Power Charge Force Frequency ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A wheatstone bridge cannot be used for precision measurements because errors are introduced into on account of Resistance of connecting leads. Thermoelectric emfs. Contact resistance. All of above. Resistance of connecting leads. Thermoelectric emfs. Contact resistance. All of above. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The total current I = I1 + I2 in a circuit is measured I1 = 150 ± 3A , I2 = 250 ± 4 A, where the limits of error are given as standard deviations. I is measured as (400 ± 1) A (400 ± 3) A (400 ±5) A (400 ± 2.24) A (400 ± 1) A (400 ± 3) A (400 ±5) A (400 ± 2.24) A ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS