Measurement and Instrumentation A DC A-h meter is rated for 15 A, 250 V. The meter constant is 14.4 A-sec/rev. The meter constant at rated voltage may be expressed as 3750 rev/KWh. 960 rev/KWh. 3600 rev/KWh. 1000 rev/KWh. 3750 rev/KWh. 960 rev/KWh. 3600 rev/KWh. 1000 rev/KWh. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The pressure coil of a wattmeter should be connected on the supply side of the current coil when Load impedance is high None of these Supply voltage is low Load impedance is low Load impedance is high None of these Supply voltage is low Load impedance is low ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Which of the following devices should be used for accurate measurement of low D.C. voltage? C. potentiometer Small range thermocouple voltmeter Small range moving coil voltmeter None of these C. potentiometer Small range thermocouple voltmeter Small range moving coil voltmeter None of these ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation In figure Z1 = 200∠60° ohm. Z2 = 400∠-90° ohm, Z3 = 300∠0° ohm. Then Z4 for bridge to be balanced is 600∠-150° ohm. 300∠90° ohm. 150∠30° ohm. 400∠-90° ohm. 600∠-150° ohm. 300∠90° ohm. 150∠30° ohm. 400∠-90° ohm. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A metal strain gauge has a gauge factor of two. Its nominal resistance is 120 ohms. If it undergoes a strain of 10-5, the value of change of resistance in response to the strain is 240 Ohm. 0.0012 Ohm. 0.0024 Ohm. 120 Ohm. 240 Ohm. 0.0012 Ohm. 0.0024 Ohm. 120 Ohm. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation If two 300V full scale voltmeters V1 and V2 having sensitivities of 100 kOhm/V and 150 kOhm/V are connected in series to measure 500V then V1 = 200V and V2 = 300V. V1 = 0V and V2 = 0V. V1 = 250V and V2 = 250V. V1 = 300V and V2 = 200V. V1 = 200V and V2 = 300V. V1 = 0V and V2 = 0V. V1 = 250V and V2 = 250V. V1 = 300V and V2 = 200V. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS