Process Equipment and Plant Design 25 per cent cut segmental baffle means that the baffle Height is 75% of the I.D. of the shell Spacing is 75% of its height Height is 25% of the I.D. of the shell Width is 25% of its height Height is 75% of the I.D. of the shell Spacing is 75% of its height Height is 25% of the I.D. of the shell Width is 25% of its height ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design __________ tower is the most suitable gas-liquid contacting device involving highly corrosive fluids. Bubble cap plate None of these Packed Sieve plate Bubble cap plate None of these Packed Sieve plate ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design Thickness of the frame of a plate and frame filter as compared to that of plates is Either A or B Less More Same Either A or B Less More Same ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design Wind load consideration in the design of a support can be neglected, when the vessel is Tall (say 30 metres), but is full of liquid Tall but empty Short (< 2 m) and housed indoor None of these Tall (say 30 metres), but is full of liquid Tall but empty Short (< 2 m) and housed indoor None of these ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design Steam is preferred to be used as a heating medium in heat exchangers, because of its Non-corrosive condensate High film co-efficient Low cost High latent heat Non-corrosive condensate High film co-efficient Low cost High latent heat ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design Weep holes provided in the plates of a distillation column Are normally located near the overflow weir so that any delivery of liquid during operation follows approximately the same path as the overflow fluid Facilitate draining out liquid from a tray when the unit is not in operation All of these Must be large enough (usually 1/4" to 5/8" dia) to prevent plugging but should not deliver excessive amount of fluid during operation Are normally located near the overflow weir so that any delivery of liquid during operation follows approximately the same path as the overflow fluid Facilitate draining out liquid from a tray when the unit is not in operation All of these Must be large enough (usually 1/4" to 5/8" dia) to prevent plugging but should not deliver excessive amount of fluid during operation ANSWER DOWNLOAD EXAMIANS APP