SSC JE Electrical 2019 with solution SET-1
Z1 and Z2 are connected in series to form a load. A wattmeter’s current coil is connected in series with the load, whereas its pressure coil is connected across Z2. The wattmeter reads
As you can see from the below figure in load Z1 is connected with the only current coil. In Load Z2 both current from the current coil (CC) and voltage from voltage coil (PC) are present (Power = V × I). Hence the Wattmeter will read power consumed by Z2.
The reluctance of any part of a magnetic circuit may be defined as the ratio of the drop in magnetomotive force to the flux produced in that part of the circuit. It is measured in ampere-turns/Weber and is denoted by S. Reluctance = m.m.f ⁄ flux
In the given diagram all are NOR Gate . The final output is shown in the figure. At stage 1 the output will be \overline A \& \overline B At stage 2 the output will be \overline {\overline A + \overline B } = A.B And the final output will be \overline {A.B} Hence for input A & B the output is \overline {AB} in case of Nand gate.
Sudden changes of load on synchronous motors may sometimes set up oscillations that are superimposed upon the normal rotation, resulting in periodic variations of a very low frequency in speed. This effect is known as hunting or phase-swinging.
EXAMIANS
