Engineering Drawing When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first. Read the coordinate position on the Dynamic Readout Enter 3 for the length of the line Insure that Ortho is on Pull the line from away from the starting point very carefully Read the coordinate position on the Dynamic Readout Enter 3 for the length of the line Insure that Ortho is on Pull the line from away from the starting point very carefully ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Isometric drawings are often used by ________ to help illustrate complex designs. Piping drafters Aerospace engineers Mechanical engineers All of these Piping drafters Aerospace engineers Mechanical engineers All of these ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing These are vertical distances above a common datum, reference plane, or point: Elevations Traverse Profiles Plats Elevations Traverse Profiles Plats ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing An advantage of this type of view is that each view shows the object all the way through as if it were transparent: Horizontal Orthographic Auxiliary Planar Horizontal Orthographic Auxiliary Planar ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line. Horizontal Vertical None of these Inclined Horizontal Vertical None of these Inclined ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches: One foot or over One yard or over One inch or over One rod or over One foot or over One yard or over One inch or over One rod or over ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS