Engineering Drawing These are vertical distances above a common datum, reference plane, or point: Traverse Plats Profiles Elevations Traverse Plats Profiles Elevations ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Center lines are used to locate or represent the centers of ________. Arcs Hidden round features Circles All of these Arcs Hidden round features Circles All of these ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Schematic and single-line diagrams should be arranged so that signal or transmission path from input to output proceeds in this fashion: Right to left and bottom to top Right to left and top to bottom Left to right and bottom to top Left to right and top to bottom Right to left and bottom to top Right to left and top to bottom Left to right and bottom to top Left to right and top to bottom ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing One critical issue drafters need to pay close attention to is the ________. None of these Designer's intent Size of the sheet Scale factor None of these Designer's intent Size of the sheet Scale factor ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line. Vertical Inclined Horizontal None of these Vertical Inclined Horizontal None of these ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing A fillet is a rounded surface on the ________ corner of a part. Radial Outside Isoplane Inside Radial Outside Isoplane Inside ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS