Engineering Drawing In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches: One rod or over One foot or over One inch or over One yard or over One rod or over One foot or over One inch or over One yard or over ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In order to convert fractional inches into decimal inches __________. All of these Divide the numerator (top number) by the denominator (bottom number) Check the engineer's scale Look on a metric conversion chart All of these Divide the numerator (top number) by the denominator (bottom number) Check the engineer's scale Look on a metric conversion chart ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part. Broken out Whole Half Offset Broken out Whole Half Offset ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In offset sections, offsets or bends in the cutting plane are all: Either 90 or 180 degrees 180 degrees 30, 60 or 90 degrees 90 degrees Either 90 or 180 degrees 180 degrees 30, 60 or 90 degrees 90 degrees ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When using the descriptive geometry method to create an auxiliary view the drafter should _________. Offset the top line of the front view 2 inches Rotate the snap grid to the same angle of the inclined plane Offset the right vertical line of the front view Rotate the top line of the front view 45 degrees Offset the top line of the front view 2 inches Rotate the snap grid to the same angle of the inclined plane Offset the right vertical line of the front view Rotate the top line of the front view 45 degrees ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Angles project true size only when the plane containing the angle and plane of projection are this: Aligned Adjacent Parallel Perpendicular Aligned Adjacent Parallel Perpendicular ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS