Engineering Drawing Switches and relays should be shown in this position with no operating force or applied energy: Application Offset Normal Closed Application Offset Normal Closed ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When using the descriptive geometry method to create an auxiliary view the drafter should _________. Rotate the snap grid to the same angle of the inclined plane Offset the right vertical line of the front view Rotate the top line of the front view 45 degrees Offset the top line of the front view 2 inches Rotate the snap grid to the same angle of the inclined plane Offset the right vertical line of the front view Rotate the top line of the front view 45 degrees Offset the top line of the front view 2 inches ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing This is an angled surface used on cylinders to make them easier to handle: Lug Fillet Chamfer Taper Lug Fillet Chamfer Taper ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Objects that are symmetric can be shown effectively using this type of section: Symmetric section Half section Quarter section Full section Symmetric section Half section Quarter section Full section ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing The most common geometric form used in gears today is this: Convolute profile Involute profile Spur circle Base circle Convolute profile Involute profile Spur circle Base circle ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing This is a conical-shaped recess around a hole, often used to receive a tapered screw head: Countersink Boss Spot-face Counter-bore Countersink Boss Spot-face Counter-bore ANSWER DOWNLOAD EXAMIANS APP