Engineering Drawing When using the descriptive geometry method to create an auxiliary view the drafter should _________. Offset the right vertical line of the front view Offset the top line of the front view 2 inches Rotate the snap grid to the same angle of the inclined plane Rotate the top line of the front view 45 degrees Offset the right vertical line of the front view Offset the top line of the front view 2 inches Rotate the snap grid to the same angle of the inclined plane Rotate the top line of the front view 45 degrees ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line. Horizontal Inclined Vertical None of these Horizontal Inclined Vertical None of these ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing The architectural drafter usually begins a set of working drawings by creating the ________ plan first. Floor plan Elevations Building section Foundation Floor plan Elevations Building section Foundation ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When lettering a CAD drawing, for clarity you should limit the number of fonts to: Two One Three Any number Two One Three Any number ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing This is the total amount that the feature on the actual part is allowed to vary from what is specified by the dimension: Difference Allowance Tolerance Specification Difference Allowance Tolerance Specification ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In architectural drawing ________ are often used to illustrate and detail structural components. Foundation beam detail sections Wall sections All of these Building sections Foundation beam detail sections Wall sections All of these Building sections ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS