When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.

Engineering Drawing
When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.

Inclined

None of these

Horizontal

Vertical

Inclined

None of these

Horizontal

Vertical

ANSWER DOWNLOAD EXAMIANS APP

Engineering Drawing
In isometric projection, all distances are approximately this percentage of their true size:

120 percent

50 percent

20 percent

80 percent

120 percent

50 percent

20 percent

80 percent

ANSWER DOWNLOAD EXAMIANS APP

Engineering Drawing
In this type of drawing, vertical pipes may be revolved into the horizontal plane:

Elevation view

Developed piping

Transverse piping

Standard view

Elevation view

Developed piping

Transverse piping

Standard view

ANSWER DOWNLOAD EXAMIANS APP

Engineering Drawing
In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.

None of these

Use the left view instead

Leave the view as is

Eliminate the view

None of these

Use the left view instead

Leave the view as is

Eliminate the view

ANSWER DOWNLOAD EXAMIANS APP

Engineering Drawing
This is a thin solid line directing attention to a note or dimension and starting with an arrowhead or dot:

Dimension line

Extension line

Leader

Specification

Dimension line

Extension line

Leader

Specification

ANSWER DOWNLOAD EXAMIANS APP

Engineering Drawing
When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first.

Pull the line from away from the starting point very carefully

Read the coordinate position on the Dynamic Readout

Insure that Ortho is on

Enter 3 for the length of the line

Pull the line from away from the starting point very carefully

Read the coordinate position on the Dynamic Readout

Insure that Ortho is on

Enter 3 for the length of the line

ANSWER DOWNLOAD EXAMIANS APP

Engineering Drawing

Engineering Drawing When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.

Engineering Drawing In isometric projection, all distances are approximately this percentage of their true size:

Engineering Drawing In this type of drawing, vertical pipes may be revolved into the horizontal plane:

Engineering Drawing In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.

Engineering Drawing This is a thin solid line directing attention to a note or dimension and starting with an arrowhead or dot:

Engineering Drawing When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first.

Engineering Drawing
When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.

Engineering Drawing
In isometric projection, all distances are approximately this percentage of their true size:

Engineering Drawing
In this type of drawing, vertical pipes may be revolved into the horizontal plane:

Engineering Drawing
In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.

Engineering Drawing
This is a thin solid line directing attention to a note or dimension and starting with an arrowhead or dot:

Engineering Drawing
When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first.