Machine Design When two helical springs of equal lengths are arranged to form a cluster spring, then Shear stress in each spring will be equal Load taken by each spring will be half the total load Only A is correct Both A and B is correct Shear stress in each spring will be equal Load taken by each spring will be half the total load Only A is correct Both A and B is correct ANSWER DOWNLOAD EXAMIANS APP
Machine Design Which of the following statement is wrong for a connecting rod? The connecting rod will be equally strong in buckling about X-axis and Y-axis, if Ixx = 4 Iyy The most suitable section for the connecting rod is T-section If Ixx > 4 Iyy, the buckling will occur about Y-axis If Ixx < 4 Iyy, the buckling will occur about X-axis The connecting rod will be equally strong in buckling about X-axis and Y-axis, if Ixx = 4 Iyy The most suitable section for the connecting rod is T-section If Ixx > 4 Iyy, the buckling will occur about Y-axis If Ixx < 4 Iyy, the buckling will occur about X-axis ANSWER DOWNLOAD EXAMIANS APP
Machine Design The face of the tooth is the Surface of the tooth below the pitch surface Surface of the tooth above the pitch surface Surface of the top of the tooth Width of the tooth measured along the pitch circle Surface of the tooth below the pitch surface Surface of the tooth above the pitch surface Surface of the top of the tooth Width of the tooth measured along the pitch circle ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be 2.8 3.5 3.0 2.5 2.8 3.5 3.0 2.5 ANSWER DOWNLOAD EXAMIANS APP
Machine Design The resistance to fatigue of a material is measured by Elastic limit Young's modulus Endurance limit Ultimate tensile strength Elastic limit Young's modulus Endurance limit Ultimate tensile strength ANSWER DOWNLOAD EXAMIANS APP
Machine Design The contact ratio for gears is None of these Less than one Zero Greater than one None of these Less than one Zero Greater than one ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS