Machine Design The lower deviation is the algebraic difference between the Maximum limit and the basic size Minimum limit and the basic size Actual size and the corresponding basic size None of these Maximum limit and the basic size Minimum limit and the basic size Actual size and the corresponding basic size None of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design For a shaft diameter of 100 mm, the number of bolts in a flange coupling should be 8 4 10 6 8 4 10 6 ANSWER DOWNLOAD EXAMIANS APP
Machine Design The objective of 'crowning' of the flat pulleys of belt drive is to Prevent the belt from running off the pulley Prevent the belt joint from damaging the belt surface Increase the power transmission capacity Increase the belt velocity Prevent the belt from running off the pulley Prevent the belt joint from damaging the belt surface Increase the power transmission capacity Increase the belt velocity ANSWER DOWNLOAD EXAMIANS APP
Machine Design The building up of worn and undersized parts, subjected to repeated loads by electroplating is Best method Extremely hazardous Has no effect as regards fatigue strength Cheapest method Best method Extremely hazardous Has no effect as regards fatigue strength Cheapest method ANSWER DOWNLOAD EXAMIANS APP
Machine Design In helical bevel gearing, the axes of shafts are __________ and the teeth are curved. None of these Intersecting and non-parallel Intersecting Non-intersecting and non-parallel None of these Intersecting and non-parallel Intersecting Non-intersecting and non-parallel ANSWER DOWNLOAD EXAMIANS APP
Machine Design The groove angle of the pulley for rope drive is usually 20° 45° 35° 60° 20° 45° 35° 60° ANSWER DOWNLOAD EXAMIANS APP