Machine Design If the tearing efficiency of a riveted joint is 75%, then the ratio of diameter of rivet to the pitch is equal to 0.2 0.6 0.25 0.5 0.2 0.6 0.25 0.5 ANSWER DOWNLOAD EXAMIANS APP
Machine Design Deep groove ball bearings are used for Combined thrust and radial loads at high speed Radial load at high speed Small angular displacement of shafts Heavy thrust load only Combined thrust and radial loads at high speed Radial load at high speed Small angular displacement of shafts Heavy thrust load only ANSWER DOWNLOAD EXAMIANS APP
Machine Design The coefficient of friction between the belt and pulley depends upon the Material of belt and pulley Speed of belt All of these Slip of belt Material of belt and pulley Speed of belt All of these Slip of belt ANSWER DOWNLOAD EXAMIANS APP
Machine Design A connecting rod should be Strong in buckling about Y-axis Any one of the above Equally strong in buckling about X-axis and Y-axis Strong in buckling about X-axis Strong in buckling about Y-axis Any one of the above Equally strong in buckling about X-axis and Y-axis Strong in buckling about X-axis ANSWER DOWNLOAD EXAMIANS APP
Machine Design In designing a sleeve coupling, length of the sleeve is taken as (where d = Diameter of the shaft) 2d + 20 mm d + 17 mm 2d + 13 mm 3.5 d 2d + 20 mm d + 17 mm 2d + 13 mm 3.5 d ANSWER DOWNLOAD EXAMIANS APP
Machine Design Two shafts of the same length and material are joined in series. If the ratio of their diameters is 2, then the ratio of their angles of twist will be 2 16 4 8 2 16 4 8 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS