Machine Design The stretching in a belt can be controlled by __________ the stress in the belt. Both A and B Increasing Reducing None of these Both A and B Increasing Reducing None of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design The objective of idler pulley in belt drive is to Increase the power transmission capacity All the above objectives Increase the wrap angle and belt tension Decrease the tendency of belt to slip Increase the power transmission capacity All the above objectives Increase the wrap angle and belt tension Decrease the tendency of belt to slip ANSWER DOWNLOAD EXAMIANS APP
Machine Design The valve rod in a steam engine is connected to an eccentric rod by Knuckle joint Cotter joint Universal coupling Bolted joint Knuckle joint Cotter joint Universal coupling Bolted joint ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a turnbuckle, if one of the rods has left hand threads, then the other rod will have Left hand threads Right hand threads Multiple threads Pointed threads Left hand threads Right hand threads Multiple threads Pointed threads ANSWER DOWNLOAD EXAMIANS APP
Machine Design In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole) 2.5 d 1.5 d 2 d 1 d 2.5 d 1.5 d 2 d 1 d ANSWER DOWNLOAD EXAMIANS APP
Machine Design A hollow saddle key is A taper key which fits in a key way of the hub and is flat on the shaft Provided in pairs at right angles and each key is to withstand torsion in one direction only A taper key which fits in a key way of the hub and the bottom of the key is shaped to fit the curved surface of the shaft A taper key which fits half in the key way of hub and half in the key way of shaft A taper key which fits in a key way of the hub and is flat on the shaft Provided in pairs at right angles and each key is to withstand torsion in one direction only A taper key which fits in a key way of the hub and the bottom of the key is shaped to fit the curved surface of the shaft A taper key which fits half in the key way of hub and half in the key way of shaft ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS