Machine Design The stress in the bar when the load is applied suddenly is __________ as compared to the stress induced due to gradually applied loads. Four times Double Same Three times Four times Double Same Three times ANSWER DOWNLOAD EXAMIANS APP
Machine Design Set screws are Similar to stud Slotted for a screw driver and generally used with a nut Similar to small size tap bolts except that a greater variety of shapes of heads are available Used to prevent relative motion between parts Similar to stud Slotted for a screw driver and generally used with a nut Similar to small size tap bolts except that a greater variety of shapes of heads are available Used to prevent relative motion between parts ANSWER DOWNLOAD EXAMIANS APP
Machine Design A key capable of tilting in a recess milled out in a shaft is known as Feather key Woodruff key Hollow saddle key Flat saddle key Feather key Woodruff key Hollow saddle key Flat saddle key ANSWER DOWNLOAD EXAMIANS APP
Machine Design Stress concentration factor is defined as the ratio of Maximum stress to the endurance limit Nominal stress to the maximum stress Maximum stress to the nominal stress Nominal stress to the endurance limit Maximum stress to the endurance limit Nominal stress to the maximum stress Maximum stress to the nominal stress Nominal stress to the endurance limit ANSWER DOWNLOAD EXAMIANS APP
Machine Design If P1 and P2 are the tight and slack side tensions in the belt, then the initial tension Pi (neglecting centrifugal tension) will be equal to (Where, Pc is centrifugal tension) [⅟₂ × (P1 + P2)] + Pc P1 + P2 P1 - P2 ⅟₂ × (P1 + P2) [⅟₂ × (P1 + P2)] + Pc P1 + P2 P1 - P2 ⅟₂ × (P1 + P2) ANSWER DOWNLOAD EXAMIANS APP
Machine Design If a spring is cut down into two springs, the stiffness of cut springs will be None of these Half Double Same None of these Half Double Same ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS