Measurement and Instrumentation The repeat accuracy of an instrument can be judged from its Dynamic error Standard deviation of error Linearity error Static error Dynamic error Standard deviation of error Linearity error Static error ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation What is the approximate input impedance of a CRO? 100 MΩ 1 MΩ 10 MΩ 0 100 MΩ 1 MΩ 10 MΩ 0 ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Assertion (A) : It is always desirable to take the reading of an indicating instrument very close to the full scale reading. Reason (R) : Accuracy of an indicating instrument is maximum at the full scale deflection and error increases as reading comes closer to the beginning of the scale. A is false bur R is true A is true but R is false Both A and R are true and R is the correct explanation of A Both A and R are true but R is NOT the correct explanation of A A is false bur R is true A is true but R is false Both A and R are true and R is the correct explanation of A Both A and R are true but R is NOT the correct explanation of A ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The time/div and voltage axes of an oscilloscope have been creased. A student connects a 1 KHz, 5 V P-P square wave calibrition pulse to channel-1 of the scope and observes the screen to be as shown in the upper trace of figure. An unknown signal is connected to channel-2 (lower trace) of the scope. If the time/div and V/div on both channels are the same, the amplitude (P-P) and period of the unknown signal are respectively 5 V, 2 ms. 7.5 V, 2 ms. 10 V, 1 ms. 5 V, 1 ms. 5 V, 2 ms. 7.5 V, 2 ms. 10 V, 1 ms. 5 V, 1 ms. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A slide wire potentiometer has 10 wires of 1 m each. With the help of a standard voltage source of 1.018 V it is standardised by keeping the jockey at 101.8 cm. If the resistance of the potentiometer wires is 1000 ohm, then the value of the working current will be 1mA. 100 mA. 10 mA. 0.5 mA. 1mA. 100 mA. 10 mA. 0.5 mA. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Ratio of readings of two wattmeter connected to measure power in a balanced 3-phase load is 5:3 and the load is inductive. The power factor at load is 0.6 lag. 0.917 lead. 0.917 lag. 0.6 lead. 0.6 lag. 0.917 lead. 0.917 lag. 0.6 lead. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS