Machine Design The notch angle of the Izod impact test specimen is 30° 45° 10° 20° 30° 45° 10° 20° ANSWER DOWNLOAD EXAMIANS APP
Machine Design A stud Has a head on one end and a nut fitted to the other Has pointed threads Has head at one end and other end fits into a tapped hole in the other part to be joined Has both the ends threaded Has a head on one end and a nut fitted to the other Has pointed threads Has head at one end and other end fits into a tapped hole in the other part to be joined Has both the ends threaded ANSWER DOWNLOAD EXAMIANS APP
Machine Design A screw is said to be over hauling screw, if its efficiency is Less than 50% Equal to 50% None of these More than 50% Less than 50% Equal to 50% None of these More than 50% ANSWER DOWNLOAD EXAMIANS APP
Machine Design If the size of a standard specimen for a fatigue testing machine is increased, the endurance limit for the material will Have same value as that of standard specimen Decrease Increase None of these Have same value as that of standard specimen Decrease Increase None of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be 2.8 2.5 3.5 3.0 2.8 2.5 3.5 3.0 ANSWER DOWNLOAD EXAMIANS APP
Machine Design An elastic bar is fixed at the upper end and loaded at the lower end by a falling weight. The shock load produced can be reduced by All of these Decreasing the modulus of elasticity of the bar Increasing the length of bar Decreasing the cross-sectional area of the bar All of these Decreasing the modulus of elasticity of the bar Increasing the length of bar Decreasing the cross-sectional area of the bar ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS