Machine Design The longitudinal stress is __________ of the circumferential stress. One-half Double Two-third Three-fourth One-half Double Two-third Three-fourth ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a full journal bearing, the angle of contact of the bearing with the journal is 180° 270° 120° 360° 180° 270° 120° 360° ANSWER DOWNLOAD EXAMIANS APP
Machine Design An open belt drive is used when Shafts are arranged parallel and rotate in the same directions Shafts are arranged parallel and rotate in the opposite directions Driven shaft is to be started or stopped whenever desired without interfering with the driving shaft Shafts are arranged at right angles and rotate in one definite direction Shafts are arranged parallel and rotate in the same directions Shafts are arranged parallel and rotate in the opposite directions Driven shaft is to be started or stopped whenever desired without interfering with the driving shaft Shafts are arranged at right angles and rotate in one definite direction ANSWER DOWNLOAD EXAMIANS APP
Machine Design The endurance or fatigue limit is defined as the maximum value of the stress which a polished standard specimen can withstand without failure, for infinite number of cycles, when subjected to Static as well as dynamic load Completely reversed load Dynamic load Static load Static as well as dynamic load Completely reversed load Dynamic load Static load ANSWER DOWNLOAD EXAMIANS APP
Machine Design When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor, and W = Axial compressive load on the spring) (WD/ πd3) × K (4WD/ πd3) × K (2WD/ πd3) × K (8WD/ πd3) × K (WD/ πd3) × K (4WD/ πd3) × K (2WD/ πd3) × K (8WD/ πd3) × K ANSWER DOWNLOAD EXAMIANS APP
Machine Design When the shaft rotates in anticlockwise direction at high speed in a bearing, it will Have contact at the bottom most of the bearing Move towards right of the bearing making no metal to metal contact Move towards right of the bearing making metal to metal contact Move towards left of the bearing making metal to metal contact Have contact at the bottom most of the bearing Move towards right of the bearing making no metal to metal contact Move towards right of the bearing making metal to metal contact Move towards left of the bearing making metal to metal contact ANSWER DOWNLOAD EXAMIANS APP