Building Construction The line of intersection of the surfaces of a sloping roof forming an external angle exceeding 180°, is None of these Ridge Hip Valley None of these Ridge Hip Valley ANSWER DOWNLOAD EXAMIANS APP
Building Construction The type of joint commonly used at the junction of a principal rafter and tie beam in timber trusses is Mitred joint Mortise and tenon joint Oblique mortise and tenon joint Butt joint Mitred joint Mortise and tenon joint Oblique mortise and tenon joint Butt joint ANSWER DOWNLOAD EXAMIANS APP
Building Construction Two columns 50 cm × 50 cm and 60 cm × 60 cm carry 80 tonnes and 120 tonnes of loads respectively. The centre to centre distance between columns is 5.00 metres. The permissible bearing capacity of the soil is 20 t/m2. If the footing is not to project more than 25 cm beyond the outside of the smaller column, pick up the correct design parameters of the footing from the following: All listed here Area of footing slab = 11.00 m2 Distance of C.G. of the loads from the smaller column = 3.00 m The length of the foundation slab = 7.00 m All listed here Area of footing slab = 11.00 m2 Distance of C.G. of the loads from the smaller column = 3.00 m The length of the foundation slab = 7.00 m ANSWER DOWNLOAD EXAMIANS APP
Building Construction The type of pointing in which upper side of mortar joints is kept about 12 mm inside the face of the masonry and bottom is kept flushed with face of wall, is Grooved pointing Truck pointing Struck pointing Recessed pointing Grooved pointing Truck pointing Struck pointing Recessed pointing ANSWER DOWNLOAD EXAMIANS APP
Building Construction The maximum total settlement for isolated foundations on clayey soils should be limited to 40 mm 100 mm 25 mm 65 mm 40 mm 100 mm 25 mm 65 mm ANSWER DOWNLOAD EXAMIANS APP
Building Construction An ordinary concrete may be made water proof by adding Pudlo Impermo Snowcem All of these Pudlo Impermo Snowcem All of these ANSWER DOWNLOAD EXAMIANS APP