Machine Design The cross-section of the arm of a bell crank lever is Rectangular I-section Any one of these Elliptical Rectangular I-section Any one of these Elliptical ANSWER DOWNLOAD EXAMIANS APP
Machine Design If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited Acme Buttress Square BSW Acme Buttress Square BSW ANSWER DOWNLOAD EXAMIANS APP
Machine Design In block brakes, the ratio of shoe width to wheel diameter is taken between 0.25 and 0.50 0.1 and 0.25 0.50 and 0.75 0.75 and 1 0.25 and 0.50 0.1 and 0.25 0.50 and 0.75 0.75 and 1 ANSWER DOWNLOAD EXAMIANS APP
Machine Design The radial distance from the __________ to the clearance circle is called working depth. Dedendum circle Pitch circle None of these Addendum circle Dedendum circle Pitch circle None of these Addendum circle ANSWER DOWNLOAD EXAMIANS APP
Machine Design Yield point in fatigue loading as compared to static loading is Higher Same Lower Depends on other factors Higher Same Lower Depends on other factors ANSWER DOWNLOAD EXAMIANS APP
Machine Design The ratio of driving tensions for flat belts, neglecting centrifugal tension, is (where T₁, and T₂ = Tensions on the tight and slack sides of belt respectively, μ = Coefficient of friction, between the belt and pulley, and θ = Angle of contact) log (T₁/T₂) = μθ T₁/T₂ = μθ T₁/T₂ = log μθ T₁/T₂ =eμθ log (T₁/T₂) = μθ T₁/T₂ = μθ T₁/T₂ = log μθ T₁/T₂ =eμθ ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS