Workshop Technology The cold chisels are made from Cast iron High speed steel Cast tool steel Mild steel Cast iron High speed steel Cast tool steel Mild steel ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology If an aluminium pattern made from a wooden master pattern is to be used for grey iron castings, then the shrinkage allowance allowed on the wooden pattern should be 16 mm/m 26 mm/m 20 mm/m 10 mm/m 16 mm/m 26 mm/m 20 mm/m 10 mm/m ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In forehand welding, the angle between the welding torch and the work is ________ as compared to backhand welding. Same None of these More Less Same None of these More Less ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The tolerance produced by shell moulding process of casting is +0.05 mm ±0.2 mm ±1 mm +0.5 mm +0.05 mm ±0.2 mm ±1 mm +0.5 mm ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology V-block is used to Check the trueness of flat surfaces None of these Locate centres of round rods Check the surface roughness Check the trueness of flat surfaces None of these Locate centres of round rods Check the surface roughness ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Tandem drawing of wires and tubes is necessary because Annealing is needed between stages Accuracy in dimensions is not possible otherwise Surface finish improves after every drawing stage It is not possible to reduce at one stage Annealing is needed between stages Accuracy in dimensions is not possible otherwise Surface finish improves after every drawing stage It is not possible to reduce at one stage ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS