Workshop Technology The operation of producing cup shaped parts from flat sheet metal blanks by bending and plastic flow of metal, is known as Squeezing Coining Planishing Drawing Squeezing Coining Planishing Drawing ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For obtaining a cup of diameter 25 mm and height 15 mm by drawing, the size of the round blank should be approximately 42 mm 46 mm 48 mm 44 mm 42 mm 46 mm 48 mm 44 mm ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology When more volume of acetylene and less volume of oxygen is supplied, then a ___ flame is obtained. Neutral Oxidizing None of the listed here Carburising Neutral Oxidizing None of the listed here Carburising ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In backhand welding, the angle between the welding rod and the work is ___ as compared to forehand welding. Less More Same None of the listed here Less More Same None of the listed here ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In a bilateral system of tolerance, the tolerance is allowed on Both sides of the nominal size One side of the nominal size Both sides of the actual size One side of the actual size Both sides of the nominal size One side of the nominal size Both sides of the actual size One side of the actual size ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The mode of deformation of the metal during spinning is Stretching Rolling and stretching Bending and stretching Bending Stretching Rolling and stretching Bending and stretching Bending ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS