Workshop Technology In backhand welding, the angle between the welding rod and the work is ___ as compared to forehand welding. None of the listed here Less Same More None of the listed here Less Same More ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In piercing operation, the clearance is provided on Either on punch or die depending upon designer's choice Half on the punch and half on the die Punch Die Either on punch or die depending upon designer's choice Half on the punch and half on the die Punch Die ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The process of increasing the cross-section of a bar at the expense of its length, is called Drawing down Spinning Upsetting Peening Drawing down Spinning Upsetting Peening ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Blanking and piercing operations can be performed simultaneously in a Compound die Progressive die Combination die Simple die Compound die Progressive die Combination die Simple die ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In sheet metal blanking, shear is provided on punches and dies so that Press load is reduced Good cut edge is obtained Warping of sheet is minimized Cut blanks is straight Press load is reduced Good cut edge is obtained Warping of sheet is minimized Cut blanks is straight ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology During drawing operation, the states of stress in cup would include Compressive stress in the flange Both (A) and (B) None of these Tensile stress in the wall Compressive stress in the flange Both (A) and (B) None of these Tensile stress in the wall ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS