Railway Engineering Number of dog spikes normally used per rail seat on curved track is one on either side two outside and two inside two outside and one inside one outside and two inside one on either side two outside and two inside two outside and one inside one outside and two inside ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering Number of cotters used in CST-9 sleepers is 5 4 2 3 5 4 2 3 ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering The purpose of providing fillet in a rail section is to Avoid the stress concentration Increase the vertical stiffness Reduce the wear Increase the lateral strength Avoid the stress concentration Increase the vertical stiffness Reduce the wear Increase the lateral strength ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering When the rail ends rest on a joint sleeper, the joint is termed as bridge joint suspended rail joint supported rail joint base joint bridge joint suspended rail joint supported rail joint base joint ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering Tensile strength of steel used in rails should not be less than 500 MPa 450 MPa 700 MPa 850 MPa 500 MPa 450 MPa 700 MPa 850 MPa ANSWER DOWNLOAD EXAMIANS APP
Railway Engineering Switch angle depends on i) heel divergence ii) length of tongue rail iii) flangeway clearance iv) throw of switch The correct answer is (ii) and (iii) (iii) and (iv) (i)and(iv) (i) and (ii) (ii) and (iii) (iii) and (iv) (i)and(iv) (i) and (ii) ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS