Analog Electronics Leakage electric current in CE configuration is normal. very small. not present. very high. normal. very small. not present. very high. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics The power dissipated by a transistor approximately equals the collector current times base supply voltage. 0.7 V. collector - emitter voltage. base - emitter voltage. base supply voltage. 0.7 V. collector - emitter voltage. base - emitter voltage. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics Which is the conversion of current done by diode ? AC to DC DC to DC None of these DC to AC AC to DC DC to DC None of these DC to AC ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics To prevent a DC return between source and load, it is necessary to use Resistor between source and load Capacitor between source and load Inductor between source and load Either A or B Resistor between source and load Capacitor between source and load Inductor between source and load Either A or B ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed 39.5mV 395mV 795mV 79.5 mV 39.5mV 395mV 795mV 79.5 mV ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics Which of the following components are used for bias compensation in transistor circuit? Rectifier diodes. Resistors. Thermistor. Both (A) and (C) above. Rectifier diodes. Resistors. Thermistor. Both (A) and (C) above. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS